Drinking water is the most underestimated infection route on the farm. An animal drinks two to three times as much water as it eats feed, yet the water lines are rarely cleaned and at house temperature form an ideal substrate for biofilm. Within that biofilm, E. coli, Salmonella, Campylobacter and yeasts survive routine cleaning and are continuously released back into the flock or herd. At the same time, moist raw materials and cooled feed form a second contamination route.
Mode of action of Protecta Liquid
Protecta Liquid is a liquid synergistic acid mixture for the treatment of drinking water, feed and raw materials. The product is built on a buffered formic acid system (formic acid with sodium formate), propionic acid, lactic acid and citric acid, supplemented with monobutyrin and a phytogenic fraction of cinnamic aldehyde, thymol and eugenol. An emulsifier system based on glycerol and monopropylene glycol keeps the essential oils in Protecta Liquid fully in solution.
The combination of formic acid with sodium formate forms a buffer system around the pKa of formic acid (3.75). A large share of the acid therefore remains available in the active, non-dissociated form across a wider pH range than with pure formic acid, while the mixture is less volatile and less aggressive in dosing. Only in that non-dissociated form does an organic acid enter the bacterial cell, donate an H+ ion and disrupt its internal pH balance. For formic acid and its salts this mode of action has been described in detail, including the effect on the composition of the gastrointestinal flora and on animal performance.
Propionic acid is the strongest organic acid against moulds and yeasts and protects moist raw materials and feed against spoilage. Lactic acid and citric acid lower the pH of the water and the feed and thereby reinforce the activity of the other acids.
Monobutyrin is the monoglyceride of butyric acid and therefore a water soluble, low odour butyrate source. It passes the stomach as a glyceride and becomes available through lipase degradation in the small intestine. There, butyric acid supplies the intestinal epithelium with energy, expands the villi surface and strengthens the intestinal barrier by driving Tight Junction assembly. Protecta Liquid thus adds a gut supporting component that a classic acid mixture does not have.
The phytogenic fraction, cinnamic aldehyde, thymol and eugenol, increases the permeability of the bacterial cell membrane, disrupts the proton balance and inhibits the formation and adhesion of biofilm. This activity is not pH dependent and complements the acids exactly where the pH is too high for acid activity: in the water line before acidification and in the small intestine of the animal. Because the emulsifier system keeps the oils homogeneously dispersed in water, no separation or oil deposition occurs in lines and drinking nipples.
Trial results for Protecta Liquid are available on request.
The benefits of Protecta Liquid are:
- One product for both drinking water (1.0 - 2.0 litre/mt) and feed and raw materials (2.0 - 10.0 kg/mt).
- Buffered formic acid system: a higher fraction of active acid across a wider pH range and less volatile in dosing.
- Broad spectrum against gram-negative bacteria, including Salmonella and E. coli.
- Pronounced mould and yeast control through propionic acid.
- Inhibition of biofilm formation in the drinking water line through the phytogenic fraction.
- Gut support through monobutyrin as a water soluble butyrate source.
- Fully emulsified: stays homogeneous in water, without separation or blocked nipples.
- A more stable gut flora and better digestion, translating into feed intake and growth.